I can see it now, "Wanted 5W tube amp under $400" ... "Hey I have a 4000W PA you could have for $17,000!"Bg wrote:nah he would have tried to sell him a PA system an encyclopedia is a bit too on point...jeremyb wrote:At least you didn't ask him for a one page schematic and he sold you an encyclopedia on tube amp building!
Jansen Owner Club
Moderators: Slowy, Capt. Black
- jeremyb
- Chorus of Organs
- Posts: 41384
- meble-kuchenne.warszawa.pl
- Joined: Sat Dec 06, 2008 9:03 am
- Has liked: 7793 times
- Been liked: 4216 times
Re: Jansen Owner Club
Slowy wrote: That's the problem; everything rewarding is just such hard work. Regret takes much less effort.
- Anvil Amps Alan
- Gibson
- Posts: 799
- Joined: Thu May 14, 2009 11:52 am
- Location: Auckland (Howick)> Paeroa
- Been liked: 89 times
Re: Jansen Owner Club
I can draw a circuit in 10 minutes if someone brings me a 4/12
"Political correctness is a doctrine, fostered by a
delusional, illogical minority, and rabidly promoted by an
unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a turd by the clean end"
delusional, illogical minority, and rabidly promoted by an
unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a turd by the clean end"
- Jay
- Vintage Post Junkie
- Posts: 7842
- Joined: Sat Sep 25, 2010 9:35 pm
- Has liked: 1645 times
- Been liked: 1312 times
Re: Jansen Owner Club
Done it! Got heaps of photos and drawing it 'professionally' now in Digikey Schematic. Hopefully you can answer a few questions i have. Hope to post things soon.Anvil Amps Alan wrote:I can draw a circuit in 10 minutes if someone brings me a 4/12
When faced with quality, I recognise it every time.
- dylan
- Gibson
- Posts: 627
- Joined: Sat Sep 02, 2006 8:24 pm
- Location: Wanganui
- Has liked: 39 times
- Been liked: 25 times
Re: Jansen Owner Club
Here is my 5/25. Far too many watts for me, was last used at an NZG jam over a decade ago, it ran on 10 for a few hours without catching fire and sounded rather nice. Since then its been revalved with tubes i was kindly given by Paul from vintageaudiovalves. I think the biasing might be iffy - standard 6l6s red plate as soon as it warms up, 6l6GC's run fine.
I really should replace all the wet caps and CC resisters, it would be a good project - but now im digital my "amp" is my old studio monitors - Behringer 2030A's
I really should replace all the wet caps and CC resisters, it would be a good project - but now im digital my "amp" is my old studio monitors - Behringer 2030A's
Mids so haunting that demons took over my living room and now my guitar glows!