Re: Folding chassis
Posted: Fri Sep 11, 2015 6:23 pm
I just use bog standard 3 inch door hinges, aluminium isn't hard to bend 
Page 2 of 2
Re: Folding chassis
Posted: Fri Sep 11, 2015 6:23 pm
actually, you know you could probably do it in a door
Re: Folding chassis
Posted: Fri Sep 11, 2015 7:05 pm
im sure the landlord would approveBg wrote:actually, you know you could probably do it in a door
Re: Folding chassis
Posted: Fri Sep 11, 2015 9:48 pm
tell him you have mice.
Re: Folding chassis
Posted: Sat Sep 12, 2015 10:10 am
Mice with average at best amp building capabilities
Re: Folding chassis
Posted: Mon Sep 14, 2015 10:42 am
Hard core when you go to 1.6mm carbon steel, did so as I could easily weld my f-ups - this is engineering if we ain't fucking things up we ain't doing anything. Could be my guitar playing too.
Use the door - brilliant lateral thinking!
Use the door - brilliant lateral thinking!
Re: Folding chassis
Posted: Mon Sep 14, 2015 4:23 pm
once a fitter, always a fitter... more a bodger really 
Re: Folding chassis
Posted: Fri Sep 18, 2015 8:36 am
How did you get on with the bender?
Re: Folding chassis
Posted: Fri Sep 18, 2015 3:06 pm
decided to see if I could squish it all in a hammond case that I allready have. Still havent got hold of decent piece of sheet stuff to give the bender a go.
Re: Folding chassis
Posted: Fri Sep 18, 2015 3:11 pm
Complete lack of being italian put him off?tubeswell wrote:How did you get on with the bender?
Re: Folding chassis
Posted: Fri Sep 18, 2015 3:21 pm
how much do you need? I still have quite a bit left from the last half sheet I bought. Could swap some for beer