NZGuitars.com

Righto, tomorrows plan is to model up the corners and 3d print them, as even the aliexpress cheapos are too small to cover all of the corner joins.

Sneak peak at the amp corner design, about to kick off a test print!

So.... bit of an update.... had a massive 3d printer fail last night, thought it was just a nozzle blockage but worse, managed to clean up the mess and thankfully had the replacement parts I needed to get it going again...

Argh so it turns out one of the fittings on the feed tube is a one use only kind of thing, have ordered more... fun.

Bg wrote: ↑Thu Jan 19, 2023 2:37 pm

jeremyb wrote: ↑Thu Jan 19, 2023 2:22 pm Should have 3d printed more corner clamps, oh well at least it’s square!

Oh I need me a 3d printer - I'll wait for next workshop, the one where things don't go rusty....

Thread dredge, taken awhile but I've got one in the mail wheres the 3d printing thread?

Bg wrote: ↑Thu Jan 18, 2024 7:32 pm

Bg wrote: ↑Thu Jan 19, 2023 2:37 pm

jeremyb wrote: ↑Thu Jan 19, 2023 2:22 pm Should have 3d printed more corner clamps, oh well at least it’s square!

Oh I need me a 3d printer - I'll wait for next workshop, the one where things don't go rusty....

Thread dredge, taken awhile but I've got one in the mail wheres the 3d printing thread?

I never did modify my corner piece model and print them