Just bought a pickup and cover for LP.
I need advice on fitting cover please.
Links would be handy too.
Fitting Humbucker Cover
Moderators: Slowy, Capt. Black
- crowbgood1
- Vintage Post Junkie
- Posts: 2893
- meble-kuchenne.warszawa.pl
- Joined: Wed Nov 19, 2008 4:19 pm
- Location: New Plymouth
- Has liked: 348 times
- Been liked: 248 times
- Vince
- Vintage Post Junkie
- Posts: 7459
- Joined: Tue Nov 11, 2008 11:31 pm
- Location: Upper Hutt The Brave
- Has liked: 389 times
- Been liked: 186 times
- Contact:
Re: Fitting Humbucker Cover
That;s called "potting" the pickups and involves dunking(? or brushing?) them in hot wax and doing it correctly which seems to be the hard bit.crowbgood1 wrote:Just bought a pickup and cover for LP.
I need advice on fitting cover please.
Links would be handy too.
There's an article here
http://www.stewmac.com/freeinfo/A-LINDYFRALIN.html
it's a bit of a plug for Lindy Fralin, but there's enough info there for it to be worthwhile.
"Vince, have you ever tried playing an expensive bass?" - Polarbear.
"And isn't that the finest acoustic bass guitar feedback solo you've ever heard?" - Billy Moose.
My Bandcamp Page
Facebook
"And isn't that the finest acoustic bass guitar feedback solo you've ever heard?" - Billy Moose.
My Bandcamp Page
- crowbgood1
- Vintage Post Junkie
- Posts: 2893
- Joined: Wed Nov 19, 2008 4:19 pm
- Location: New Plymouth
- Has liked: 348 times
- Been liked: 248 times
Re: Fitting Humbucker Cover
Thanks..another good article. Problem is I've found a few good articles on the net and they are all different.
One I looked at on u tube they dunk the pickup with cover fitted into wax bath.
I doesn't look to difficult. (or is it harder than it looks)?
One I looked at on u tube they dunk the pickup with cover fitted into wax bath.
I doesn't look to difficult. (or is it harder than it looks)?
A sure cure for seasickness is to sit under a tree.
- ash
- Vintage Post Junkie
- Posts: 7505
- Joined: Mon May 10, 2004 4:01 pm
- Location: Auckland, NZ
- Has liked: 3 times
- Been liked: 5 times
Re: Fitting Humbucker Cover
You need to push the cover on so the poles stick out a bit and then solder the cover to the baseplate both sides. Then you do the wax job.
http://ashcustomworks.com for custom built electric guitars hand made in new zealand
- crowbgood1
- Vintage Post Junkie
- Posts: 2893
- Joined: Wed Nov 19, 2008 4:19 pm
- Location: New Plymouth
- Has liked: 348 times
- Been liked: 248 times
Re: Fitting Humbucker Cover
Ok..... I'm getting confused with too much conflicting info on the net.
I might just get our local guitar tech down here to do it.
But that was what I planned on doing (push cover over pup, solder at base, melt some paraffin wax, then bath the pup).
Then I got googling...now I'm confused.
I might just get our local guitar tech down here to do it.
But that was what I planned on doing (push cover over pup, solder at base, melt some paraffin wax, then bath the pup).
Then I got googling...now I'm confused.
A sure cure for seasickness is to sit under a tree.