NZGuitars.com

Hi guys. Im rehousing a Behringer HM300 as the plastic case it is in puts me way of it... just seems to be ready to break.

I dont know how Im going to rewire it though as have never come across this type of scenario in my already limited experience with such things.

Yeah.. any help?




Replaced with this:



Hopefully its a straight forward fix or I'll just keep it plastic and fantastic.

Cheers

i remember asking tony about this and he was keener just to make one:)
honestly if you arent out on the road the casing is fine-ive had mine for about 5 years and it works perfectly.And thats with gigging it.

just sucks thats its goddamn fruitstick pink!

It feels so flimsy and yuck. the only weight to it is a steel plate they put underneath

Two ways you can do it, if you don't mind keeping the original buffer circuit in place then just pull that switch out and solder in two wires to a momentary footswitch (not latching like you have), otherwise you need to find the fet that does the buffering on the board and bypass it, so you can then wire the sockets and everything into your switch like a normal true bypass pedal.

I vote momentary, far easier, alternately, wire the 3pdt from your case jacks, to the leads that were attached to the original jacks, if you must have true bypass. You may need to include a momentary external switch in case it defaults to off when you power down, which is likely. Get the meter out