NZGuitars.com

I wanna check this, because if I wire up wrong vewy baad things will happen

To wire up the 2 speakers, can I hook up one speaker as you normally would if you had a single cab for example, and then just run a wire from the positive terminal of the 'other' speaker to the positive terminal of the 'active' speaker (and repeat for the negative terminal)?

confused?

I made Epiphone!! *hugs himself with joy*

yep, but remember your total impedance will change

Apart from the impedance change (if spkrs are the same impedance (eg 8 Ohm), two spkrs in llel will give 4 Ohms), also be sure you apply DC voltage, say from a 9V battery to the spkrs and that they both move in the same direction - both push or both pull.

cheers...handy tip Rog!